TCMT16T308-MF2 CP500 Triangular Turning Insert Single Sided With Centre Hole 4089260 Flywheel Material: Stock

Flywheel Material: Stock

The high performance S-Gash geometry on the ball improves shearing while reducing the load

Teng 1/2In Dr

Trim the leads to the required length

Skins over in a short time – To resist dirt and dust pickup

TCMT16T308-MF2 CP500 Triangular Turning Insert Single Sided With Centre Hole 4089260 Flywheel Material: StockCP500 Grade: Tough micrograin grade intended for finishing to medium roughing of stainless steels but with wide applicability for example in steels and aluminium alloys. Especially suitable in intermittent cuts. (Ti,Al)N + TiN p>MF2 Chipbreaker: First choice for finishing with negative inserts. Suitable for chip control at depths of cut down to 0,25 mm, provided that the feed rate is in excess of 0,25 mm rev. Good capacity for medium rough machining.