DNMG150604-MF2 TP1501 Turning Insert DR901 Few tools can match the

Few tools can match the strength

Thread 3/8" UNC Left Hand

With most vehicles you simply remove the disposable air filter and replace it with a K&N

Wheel Bearing Kit - To Suit FIAT DUCATO MK II 2WD & 4WD

1-4 Morse Taper Hardened and Ground Drill Sleeve

DNMG150604-MF2 TP1501 Turning Insert DR901 Few tools can match theTP1501 Duratomic technology coated grade. Highly heat and wear resistant grade extremely well suited for productive general turning of steels and a useful backup in other material groups. Ti(C,N) + Al2O3 + Used Edge Detection (Chrome) MF2 Chipbreaker: First choice for finishing with negative inserts. Suitable for chip control at depths of cut down to 0,25 mm, provided that the feed rate is in excess of 0,25 mm rev. Good capacity for medium rough