Underbody Spring Assembly without Arm Connector Holcombe without splines so it can

without splines so it can free spin

these stationary bows are commonly utilized to fasten the front and rear vinyl caps to a trailer in a side to side rollover tarp system

CPS changed the board width of their belly dump trailers from 90" to 94" between 2005 and 2008 so make sure to measure and select the correct width if your trailer falls within or before that range

these arms are simple and affordable to replace

Works on any pivot pin

Underbody Spring Assembly without Arm Connector Holcombe without splines so it canThis spring assembly is designed for flip tarp arm systems on dump trucks and trailers. It replaces part numbers K0511B and K0512B and has a hex end shaft. This kit includes Torsion Spring (AP8203 AP8204) Spring Retention Plate 1" Flange Bearing (BF3009) 1" Pillow Block Bearing (BF3010) Hex End Pivot Shaft (AP8201) Hardware