Camber Roller for Mark II Honing Guide PT01-14 A restocking fee of up

A restocking fee of up to 25% may apply

creating a 3/8" tunnel to enable table saw rips as thin as 1/8"

Complete with instructions

elegant touch to any kitchen

1/8" Collet

Camber Roller for Mark II Honing Guide PT01-14 A restocking fee of upOn smoothing planes, its desirable to hone a slight curve into the edge of the blade to eliminate blade tracks in the piece of wood being planed. The Veritas Camber Roller Assembly has a barrel shaped roller that permits a limited rocking of the blade while still maintaining an accurate consistent bevel. Simply replace the roller on the Mk. II Honing Guide with the camber roller; thats it! Setup is still done using the Mk. IIs registration jig, plus